SES SAT DBPX, User/Installer Manual

Page: 8 / 36

SAT DBRX V1.0 INSTALLATION AND USER GUIDE
4
2.0
INSTALLATION INSTRUCTIONS
NOTE THE FOLLOWING BEFORE ATTEMPTING ANY INSTALLATION:
A. Never install telephone wiring during a lightning storm.
B. Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
C. Never touch uninsulated telephone wires or terminals unless the telephone line has b e e n
disconnected at the network interface.
D. Use caution when installing or modifying telephone lines.
E. Installation of SAT DBRX requires co-ordination with your telephone company. It is
recommended that a Touch-Tone line be installed to allow much faster dialing. If a Touch-Tone
T M T M
line is not available, the SAT DBRX can be reprogrammed to dial out pulse (rotary) signals.
F. The phone company may require the following information:
The ringer equivalence number.
The FCC registration number.
These numbers are indicated on the label on the back of the SAT DBRX.
The desired location of the telephone jack must be given to the phone company at the time
the phone line is ordered.
G. Actual installation of the SAT DBRX involves:
1) Grounding the SAT DBRX to earth ground from the terminal on the SAT DBRX.
2) Wiring the supplied transformer to the terminal strip on the back of the SAT DBRX and
plugging it into a 110 vac outlet.
3) Connecting the supplied phone line into the RJ-11C jack provided by the phone
company.
4) Connecting the optional IBM PC or XT compatible keyboard. (See Pg. 24)
5) Connecting an RS-232 serial device such as a printer or terminal to the DB-25
connector on the back of the SAT DBRX. (See Pg. 21).