Servomex 07931001B, Operator'S Manual

Page: 151 / 221

07931001B revision 6 © Servomex Group Limited. 2020
137
Figure 7-10 Alignment tool
The alignment tool comprises a LED light source and eye pieces which are fitted to
an adaptor on each opposing flange. Align in accordance with tolerances in section
7.1.4 by lining up the eye piece with the light source until the LED source is
concentric to the relative bores and eye piece.
For extended path lengths (over 5 meters) an eye piece with integrated scope is
available with an optical magnification factor of 4X and crosshair target.
The alignment tool is NOT Ex certified.
It CANNOT be used where a FLAMMABLE atmosphere is present in the
‘Outside atmosphere’ or the ‘process atmosphere’.
It MUST NOT be used where an EXPLOSIVE atmosphere is present in the
‘outside atmosphere’ or the ‘Process atmosphere’.
The alignment tool must not be used where there is a risk of exposure to
hazardous gases contained in the process.
Fitting the transmitter and receiver on the flange
Inspect all joints when you have connected the Laser 3 Plus to the
process.