SerVision MVG200, Configuration And Management Manual, Page: 234 / 241

SerVision Embedded Video Gateway System Guide
Appendix A: Viewing Video on a CCTV Monitor (TV-Out) 233
Viewing System Information on the Monitor
You can view the following system information on the monitor:

Name of the unit

Main private IP of the unit

Secondary (zero-conf) private IP of the unit

Net mask

Firmware version


 To view system information:

In the main monitor menu, select Sys info . The
System Information
screen opens:
Figure 276: System Information screen
Using PTZ Controls
If cameras with PTZ controllers are connected to the Video Gateway, and the controllers are connected to the unit
and activated in the unit's configuration, you can perform the following tasks on the monitor:

Move the cameras using all the supported features of the camera: pan, tilt, and zoom

Select and save a preset location

Move the camera to a preset location



To use PTZ controls:
1. In the main monitor menu, select PTZ . The
PTZ
menu opens.