SerVision
Embedded Video Gateway System Guide
Saving Configuration Changes
158
Figure 185: Restart confirmation message
Note:
To continue configuring the unit, wait at least 30 seconds, and then click the link and log into the
configuration utility again.
Note:
If you do not restart the unit at this time, most changes are not implemented on the unit, but they are
saved on it. The next time the unit is reset, the changes are implemented.
Discarding Changes
Once you have saved a change to the unit's settings in the configuration utility, the change is stored on the unit.
When the unit is next restarted, the change is implemented. If the unit has not yet been restarted, you can choose to
cancel all configuration changes that were not yet implemented. If you choose this option, changes that have not yet
been implemented are erased from the unit, and are not implemented when the unit restarts.
To discard all configuration changes that were saved but were not yet implemented:
1. In the
Main Menu
, under
System
, click
Save Settings
. The
Save Settings
screen opens.
2. In the
Save Settings
screen, click
Discard Changes
. The changes are canceled, and the
Changes
Discarded
screen opens: