W A S H I N G
M A C H I N E
10
SM1602
PLUMBING INSTALLATION
Location
Modern washing machines spin at high speed. To avoid excessive vibration during spinning, install the appli-
ance on a properly supported floor. Always leave at least 5cm of space on each side of the appliance to allow
for possible vibration during spinning of unbalanced loads.
Space for servicing and fitting
Allow space on either side of the appliance for access and servicing.
Water Board Regulations
These instructions are intended only as a general guide and local by-laws and water board regulations
regarding the water connections and drainage from the appliance must be observed.
Water Pressure
The appliance will operate within a wide range of water pressures.
Hot Water (if fitted)
minimum 5 N/cm2 (0.5 bar) (7 psi)
Red Coloures
maximum 10 N/cm2 (1 bar) (15 psi)
Cold Water
minimum 5 N/cm2 (0.5 bar) (7 psi)
Bleu Coloures
maximum 100 N/cm2 (10 bar) (150 psi)
The height of the storage tank in the house must be a minimum of 8 feet above the top of the appliance to
meet the minimum pressure requirements.
Permanent plumbing
If only cold water supply is available it will be necessary to fit a special adap-
tor (Fig 10).
Both the hot and cold hoses are provided with a standard 3/4 “ B.S.P female
connector which is to be fitted to a suitable tap.
The hot water inlet can be
identified by the red coloured filter inside the inlet valve.
Remember to fit
the rubber washers into the ends of the hoses prior to connection to the
supply or appliance.
Water Supply
1
Most domestic hot water systems are suitable.
2
Multi-point gas heaters can be used if sufficient water pressure is available (check with manufacturer).
3
Single point instantaneous gas water heaters MUST NOT BE USED.
4
If you are in any doubt about the suitability of your hot water system, consult the manufacturer of the
heating appliance or the Gas or Electricity Board.
Water Connections
All the connections and adaptors mentioned in this section can be purchased from your local builder, plumber
or from large DIY stores and electrical outlets.
Filling hoses
All our washing machines are supplied with special high pressure filling hoses
complete with a 3/4” BSP (19mm) female coupling.
Important:
Under no circumstances should this coupling be removed from
the hoses (Fig 11).
We will not accept any responsibility for failure of the hoses or water connec-
tions if the factory fitted couplings are removed. The hoses are designed to
be long enough to stay connected while the appliance is pulled forward for
cleaning and servicing.
Fig 10
Fig 11
