Operating Manual
Multi-‐Data Terminal
model: SB-HCM-600
Multi-‐Data Terminal
When the power switch is turned on, the number on the LED screen will show 8_ _, _8_, _ _8, 333, 222, 111 and
000 with short beeping sounds.
Then the screen is blank, which is the stand-by status.
If you keep pressing “CALL” button sequentially while the LED screen is blinking, the receiver may not function
properly. Please press the button slowly.
<How to register the Multi-Data Terminal to the receiver>
You can register the Multi-Data Terminal to both types of receiver(Display panel-type/Wristwatch-type) in the same
way.
Step 1.
First, enter “Registration Function for Multi-Data Terminal”.
Step 2.
Receiver’s screen will display “001” and “1” blinks.
(Some receivers will show “(0)00”, then make the number “(0)01”.
Step 3.
Now press “FNC” button on the Multi-Data Terminal and number “0” twice. Lastly, press “CALL” button.
(FNC
à
00
à
CALL)
* FNC button is shown as “REC” on the screen of the Multi-Data Terminal.
Step 4.
The numbers both on receiver and the Multi-Data Terminal will blink twice. Now the Multi-Data Terminal is
registered to the receiver.
* You can register 5 Multi-Data Terminals to each receiver. So, in Step 2, registering number is limited from
001~005. (Each number matches to each Multi-Data Terminal.)
