Server Technology Sentry PT22, Installation And Operating Manual, Page: 13 / 74

Environmental Monitoring
Input Load
The Input Load page displays the tower(s) absolute and descriptive name and the cumulative input load
in amperes of all devices attached to the Sentry at the time the page was loaded. This page will refresh
automatically every 10 seconds.
Sensors
The Sensors page displays:
•
Temperature/humidity sensor’s absolute and descriptive names
•
Temperature/humidity sensor readings in degrees Celsius and percent relative humidity
Configuration
The Configuration section offers access to all unit configuration options including Network,
Telnet/SSH, HTTP/SSL, Serial Ports, Users, FTP, Proxy/SNTP and SNMP. This section is available to
administrative level users only.
System
The System configuration page is used for reference of system information such as Ethernet NIC Serial
Number, Ethernet MAC address and system firmware and hardware revisions as well as assignment and
maintenance of the system location and tower descriptive names.
For description names, up to 24 alphanumeric and other typeable characters (ASCII 33 to 126 decimal –
spaces are not allowed) are allowed.
NOTE: Spaces may be used for the location description only.
Creating a descriptive system location name:
Enter a descriptive name and press Apply .
Creating a descriptive unit name:
Click on the Tower Names link.
On the subsequent Tower Names page, enter a descriptive name and press Apply .
Creating a descriptive input feed name:
Click on the Input Feed Names link.
On the subsequent Input Feed Names page, enter a descriptive name and press Apply .
Creating a descriptive outlet name:
Click on the Outlet Names link which will open the Outlets configuration page. See Outlets on page
16 for additional information on creating descriptive outlet names.
Creating a descriptive serial port/Pass-Thru name:
Click on the Serial Port Names link which will open the Serial Ports configuration page. See Serial
Ports on page 15 for additional information on creating descriptive serial port names.
Creating a descriptive Environmental Monitor name:
Click on the Environmental Monitor Names link.
On the subsequent Environmental Monitor Names page, enter a descriptive name and press Apply .
Creating descriptive sensor names:
Click on the Sensor Names link.
On the subsequent Sensor Names page, enter a descriptive name and press Apply .
Sentry PT22 Operations
•
13
Installation and Operations Manual