Sequential PRO 3, User Manual

Page: 22 / 168

10 Saving a Program Sequential
You can also recall the Basic Program by simultaneously pressing the
trans
-
pose down
and the touch slider’s
latch
button.
Chapter 3 provides a selection of simple sound design tutorials. It’s designed
to give you a basic working knowledge of how to use the Pro 3 to make your
own sounds. See “Chapter 3: Programming the Pro 3” on page 104.
Saving a Program
If you’ve created a sound that you like, you’ll probably want to save it.
Saving a program overwrites a previously saved program. Sound design-
ers often save many incremental versions of a program as they continue
to refine it. These intermediate versions often make good jumping off
points for new sounds.
To save a program to the same preset location:
1. Press the
write
button. Its LED begins blinking.
2. Enter a name for the program using the appropriate Soft Knobs and
Soft Button. (See the illustration that follows for their functions.)
3. Press the
write
button again. Its LED stops blinking and the program is
saved.
To save a program to a different location:
1. Press the
write
button. Its LED begins blinking.
2. Turn the
bank
or
program
knobs (or Soft Knob 1 and Soft Knob 2) to
select a new location. You can only save to
banks U1-U4
.
3. Enter a name for the program using the appropriate Soft Knobs and
Soft Buttons. (See the illustration that follows for their functions.)
Press the
write
button again. Its LED stops blinking and the program is
saved.