© Seon Design Inc. | August 2017 | All rights reserved. www.seon.com Part Number: 700-1096 R1
8-Port PoE Expansion Kit
- Quick Install Guide
Kit Contents
(NRPOE08-KIT)
• 8-Port PoE switch (NRPOE08)
• Includes 2 x wall mount brackets and 6 x flathead M3
screws
• PoE Hardware Kit (020-1039)
• 4 x No. 10 self-drilling mounting screws - 3/4” length
(600-0038)
• CAT5 cable - 3’ length (085-0082)
• 16-gauge black ground wire - 10’ length (410-0033G)
• 16-gauge red power wire - 3’ length (410-0034G)
• 16-14 butt splice (444-1025)
• Relay Kit (020-1040)
• Relay (450-1001)
• Relay socket harness (060-1082)
• 15A fuse and holder (420-1000)
• 2 x 16-16 butt splices (444-0071G)
• No. 10 mounting screw - 3/4” length (600-0038)
This kit supports up to 8 external IP cameras (16 IP cameras
using the optional second PoE switch) operating with the Seon
NX16 Hybrid NVR in default NVR mode.
For camera configuration details and NX16 NVR product
documentation, visit
community.seon.com
. If you do not have
access credentials, please contact Seon Customer Service.
Important
: NX16 DVR mode is not compatible with
this expansion kit. For more information, see the NX16
documentation, or contact Seon Customer Service.
Location
Avoid exposure to water drips and installation
locations with heat or moisture. Route wiring
and cables away from sharp edges that might
damage insulation. Avoid sharp bends in cables.
Surface
Do not mount the PoE switch to a plastic panel
or other surface subject to constant vibration.
Clearance
Allow sufficient clearance above the PoE switch
for access to the terminal block wiring, and
in front of the PoE switch for the camera and
uplink connections.
Ventilation
To prevent overheating, ensure airflow
around the PoE switch is unrestricted - include
minimum 3/4” clearance for the top and bottom
venting holes.
Installation Requirements
Step 1: Mount the PoE Switch
Replace Rail Mount with Wall Mount Brackets
First, remove the DIN rail plate and install the supplied wall
mount brackets:
1. Rotate the device to the far side and locate the DIN rail
mounting plate.
2. Remove the 3 screws securing the rail mounting plate to
the rear panel of the PoE switch.
3. Align the wall mounting brackets on the rear sides. The
screw holes on the device and the mounting brackets
must be aligned.
4. Secure the wall mount brackets with the 6 M3 screws:
Installation Diagram
