v 1.91 280621
The step-by-step installation procedure
•
connect the GROUND cable,
•
then c 12V,
•
set a 5-digit program number dedicated to the car, using the PCB button and LED (see: setting
the 5-digit program number); the program number can also be set using the
O351 interface
.
•
connect CAN L,
•
connect CAN H,
•
in case of SEO CANblu P/N 3977xxxx connect also LIN1,
•
set the PIN code to be used when disarming the immobilizer (optional).
ATTENTION! Do not use the power supply from the OBD port. To increase security you could
consider removing the CAN wires from the OBD connector (or connect these wires with the use
of a relay and PIN9 of SEO device) ii you choose to do this the garage/workshop should be
informed at every visit.
The SEO CANblu immobilizer can only communicate with the CAN bus when it’s properly
connected and transmission has been established, i.e. the LED on the main unit flashes. Always
connect all wires indicated in the connection diagram. Disconnecting the device or just cutting the +
12 V power wire will prevent the device from working effectively.
The user should be informed
where the SEO CANblu main unit has been mounted.
By default, the device is set to the neutral
program number 11120.
ATTENTION! After setting the program number and installing the device, the immobilizer will
not block the car, if the PIN code has not been set or the wireless transmitter has not appeared
within the SEO CANblu signal range. The wireless transmitter must appear in range of the
SEO CANblu at least once or the PIN code must be set for the immobilizer to block the car
The SEO CANblu immobilizer can work with any AVL (Automatic Vehicle Location) device
equipped with a control output. Connecting the device to a GPS/GSM tracker enables remote
immobilization. An external constant grounding on PIN6 in SEO CANblu P/N 2761xxxx or on PIN2
in SEO CANblu P/N 3977xxxx of the 10-PIN immobilizer connector immobilizes the vehicle whether
or not the immobilizer has previously been disarmed with the PIN code. This method of
immobilization works even in service mode. If PIN6 in SEO CANblu P/N 2761xxxx or PIN2 in SEO
CANblu P/N 3977xxxx is grounded while the vehicle is in motion the immobilization will occur after
the vehicle has stopped and the ignition is switched off.
A version of the SEO CANi that is used only with GPS/GSM trackers (without the option of using
PIN code) is also available. Another version of SEO CANblu is also available, please check
Add-on
for SEO CANblu
on the last page of this document
The SEO CANblu immobilizer will not disarm when the car is opened using the lock cylinder (using
the key). The immobilizer can only be disarmed when the car is opened with a remote control or
keyless.
It should be possible for the user to cut off the power supply to the device in an emergency (e.g. by
adding a fuse in the fuse box, the removal of which will cut off the power supply to the device, or
informing the user about the place of installation of the device)
