Sentera Controls MT, Mounting And Operating Instructions

Page: 6 / 8

www.sentera.eu
MIW-MT-EN-000 - 18 / 10 / 2021 6 - 8
back to the table of contents
MT
ELECTRONIC FAN SPEED
CONTROLLER
MOUNTING INSTRUCTIONS IN STEPS
Before you start mounting the unit, read carefully “Safety and Precautions” . Then
proceed with the following mounting steps:
For inset mounting
1.
Remove the knob by turning it to the right until it pops out.
2.
Unscrew the loose nut to remove the cover of the external enclosure.
3.
Do the wiring according to the wiring diagram (see Fig. 1 “ Wiring and connections” ).
Fig. 1 Wiring and connections
Minimum
speed
adjustment
trimmer
Fuse holder with a spare fuse
4.
Mount the internal enclosure into the wall according to the mounting dimensions
shown in
Fig. 2 . “ Mounting dimensions - inset mounting”.
Fig. 2 Mounting dimensions - inset mounting
82
82
26 33
50x50
62
50
62
60
62
50
62
60
5.
Turn on the mains voltage and the controller.
6.
Adjust the minimal speed and turn off the controller.
7.
Mount back the cover using the nut.
8.
Put back the knob and turn it to off position.