Gate bypass module
5 - 24 • • • Intelli-FLEX II product guide
Local gate bypass module
Operation
When the key is in the access position:
•
The sensor cable is shunted around the gate or terminated at the gate,
depending on the particular configuration.
•
The status contacts close giving a signal to an annunciation device.
If the faceplate assembly is removed from the bypass module housing, a tamper
switch will open, supporting an indication, when wired appropriately, to an
annunciation device.
Interface
The terminal block is an 11-position, stripped bare-wire, screw-clamp, style
device. The connections to the annunciation device are consistent regardless of
bypass configuration on the gate or fence. These connections are typically fed
through conduit, off the fence, underground, to the transponder housing for
interface to the annunciator, or to the local key box mounted for convenient
access from vehicles, or the walkway.
Connection details are given for each situation in the following sections.
Figure 5-24 Local gate bypass module terminal block
