Initializing the hard disk
3 - 10 • • • Senstar 100 Installation guide
Multiple CUs require a unique QNX network node number
assigned to each CU. It is recommended that you assign node
numbers that correspond to the CU numbers, i.e.,
node#1=CU#1, node#2=CU#2, etc. However, if you are
operating a single CU system, simply assign the default node
number to the CU.
Creating a system initialization file
1. Press
Enter
to begin creating the system initialization file.
DO NOT press
Enter
to complete steps 2 through 5.
2. Specify the time zone in which the system will operate by typing the character
that corresponds in the list. For example, press
u
to specify the Eastern
Standard time zone.
3. Type
g
to specify Greenwich Mean time as the setting for the real time clock.
4. Type
4
to specify the number of QNX consoles.
Step 5, to use a mouse, applies only to the QNX operating
system. It does not affect the use of a mouse with the Senstar
100 System.
5. Type
n
at the prompt to use a mouse with this machine.
Configuring a network computer
Senstar-Stellar recommends that the QNX network be
configured OUTSIDE of the QNX installation program. If you
require a QNX network, see Installing a QNX network, page 4-
16.
1. When prompted as to whether the computer will be on a QNX network,
type
n
.
Initialization completes and the
Senstar 100 Startup Program
menu
displays.
Ca
uti
on
