Initializing the hard disk
3 - 8 • • • Senstar 100 Installation guide
3. Specify how much of the hard disk you want QNX to use by typing the letter/
number that corresponds to the desired partition size.
If you do not know how much of the hard disk you want to use,
you can edit the partition table by pressing “
e
”.
Initializing the QNX file structure
1. Press
Enter
to begin initializing the QNX file structure.
The QNX installation program initializes the file structure.
2. When prompted, press
Enter
to continue.
3. Specify a method to test for bad blocks on the hard disk, by typing one of the
following:
4. Press
Enter
to begin the selected test.
5. When the test is complete, press
Enter
.
Depending on the block test that you selected and the size of
the hard disk, the testing may take a substantial amount of
time to complete.
r -
(read only)
tests that each block can be read
w -
(read/write)
tests that each block can be written to and read
v -
(read/write/verify)
tests that each block can be written to and read, and verifies
both procedures
