sensolus TRACK 1000 Replacement Manual Download Page 1

www.sensolus.com | [email protected]

 TRACK 1000 Battery replacement manual

Step 1

• 

Make sure that the serial number and logo are facing 
the right way up.

• 

Then turn the tracker face down.

• 

Unscrew the 6 screws.

Tip: If using a power drill, use power setting 7, on low. 

(Note: not all power drills have the same settings!)

Step 2

• 

Remove the back plate and the 6 screws.

Step 3

• 

Remove the batteries - pull them out of the 

connector.

Tip: place a finger on the sponge to hold it in place

Step 4

Place the chip so the connector is towards the holder.

Step 5

Insert new batteries. Position the new batteries and make 

sure the batteries are in the center (on top of the sponge) 

- not too low or too high.

Step 7

Make sure that the seal is completely flat/intact on the 

back of the tracker. 

Step 8

Close the case again by tightening the 6 screws in the 

corresponding holes. Be careful not to break the casing 
when using a power drill.

Step 9

The green light on the front of the tracker will rapidly 

flash green. From this moment, your asset tracker will 

start sending activity (movement) and GPS location. 

This information will be visible in the Sensolus Platform 

if you find yourself in an area with Sigfox communication 

network coverage.

Step 6

Make sure the connector is inside the holder and that the 

cable is tucked to the left-hand side.

Reviews: