| IoT-Gateway-00 SERIES
12-24V DC POWERED OPERATING MANUAL
C
opyright © 2021 Sensata Technologies, Inc.
Page 3
1.0 INTRODUCTION
1.1 Safety Information
This manual contains information that must be observed in the interest of your own safety
and to avoid damage to assets. Please read this manual before installing and
commissioning the device and keep the manual in an accessible location for all users.
Contains FCC ID: W70MRF24J40MDME
& FCC ID:
Caution: To satisfy FCC RF Exposure requirements for mobile and base station
transmission devices, a separation distance of 20cm or more should be maintained
between the antenna of this device and persons during operation. To ensure compliance
operation at closer than this distance is not recommended. The antenna used for this
transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. No other antenna may be used with this equipment other than the PCB
antenna supplied with this equipment.
Please see Certifications section for more information on RF Exposure Compliance
1.2 Hardware Features
The IoT-Gateway-00 receives data from IWT Wireless sensors and other wired inputs
and sends the data it receives to a remote server using the in-built IoT cellular modem.
The unit also features a 6 line LCD display which can display the latest readings from
connected sensors together with the current IoT Gateway configuration information.
By using the two pushbuttons on the fron panel the user can cycle through the data
received and also view or change the configuration settings of the IoT-Gateway.
The sensors the IoT-Gateway-00 can receive data from as standard are as follows:
•
Up to 128 off IWT single parameter wireless sensors
•
Up to 4 off 4-20mA or 0-10V wired sensors
•
Up to 8 off switch volt-free contact inputs
Please enquire about OEM versions which also allow data to be read from orher
equipment with RS485 or Ethernet communications.
The IoT-Gateway-00 also features 4 off relay outputs which can act as high/low alarm
relays for any of the received data, whether from wireless or wired sensors.
The unit is powered from a 12-24 Vdc supply and is housed on an IP67 wall mounted
enclosure.