Chapter 1: Installation
27
Rear Panel
The rear panel is where the main power switch is located. The main power cord attaches to the
IEC320 connector. The unit can be powered from 100–250VAC 50–60Hz.
ON/OFF Switch
The on/off switch connects main power and battery power to the system. Note that the system will
only turn on when main power is present. When main power fails, the internal battery will auto-
matically supply power to the unit.
Figure 2: Rear Panel of the IMS Host
Installation
This section provides information on:
n
Operating environment
n
Rack, wall, and tabletop installation
n
Connecting sensors
Parts Required
Phillips
9 pin F/F null
Dumb terminal or PC
Screwdriver
modem cable
w/9 pin com port
Operating Environment
Before you install the IMS-4000 Host be sure that your operating environment meets the physical
requirements of the equipment.
Operating Temperature: 32º–
122º Fahrenheit (0
º–
50º C)
Humidity:
5–90 %RH, non-condensing
Power:
100–250VAC 50–60 Hz outlet within 6'
Rack Requirements:
Standard 19" equipment rack with supplied mounting bracket
hardware. Requires 1.0 EIA rack mount space.
Tabletop requirements: Flat area which can support an enclosure 17" wide by 10" deep by 2"
high.
Rack Mount Installation
The IMS-4000 Host can be rack mounted using the included rack mount brackets. Follow the steps
below:
Summary of Contents for IMS-4000
Page 2: ......
Page 3: ...IMS 4000 User s Manual Version 2 5 5 SENSAPHONE...
Page 170: ...IMS 4000 Host Installation Manual 168 Test Log...
Page 171: ...Appendix F Test Log 169...