Synchronizing the transmitter with the EK 2000 IEM receiver
31
Operation without
network
왘
First carry out the
Easy Setup Sync
function
(see table on page 16, left-hand column).
The transmitter is set to a suitable frequency.
왘
Then carry out the
Sync
function once for each transmitter/receiver pair (see table on
page 16, right-hand column).
This establishes a transmission link between the transmitter and the receiver.
Using freely selectable transmission frequencies
You can also freely select the frequencies and store these frequencies in the frequency banks
“
U1
” to “
U6
”.
If you want to use the frequency banks “
U1
” to “
U6
”:
왘
Make sure to use transmitters and receivers from the same frequency range (see page 4
and the type plates of the devices).
왘
Set each transmitter to the same frequency bank.
왘
On one of the transmitters, select a channel within this frequency bank (see page 25).
왘
Assign this channel one of the calculated transmission frequencies (see page 25).
왘
Synchronize a receiver with your transmitter (
,
see page 16).
OR
왘
Manually set the receiver to the same frequency bank, channel and frequency that you set
on the transmitter.
왘
Repeat for the remaining transmitters and receivers as described above.
To ensure that the desired frequencies are intermodulation-free:
왘
Contact your Sennheiser partner (see www.sennheiser.com).
