Sennheiser SR 2000 IEM - ANNEXE 1, Instruction Manual

Page: 29 / 44

Adjusting settings via the operating menu
27
왘
Set the desired frequency.
Adjusting the receiver parameters and activating/deactivating their transfer to
the receiver – “Sync Settings”
Via the “ Sync Settings ” submenu, you can adjust the following parameters for the
EK 2000 IEM receiver.
You can specify for each parameter whether it is to be transferred to the receiver during
synchronization.
By pressing the button on the transmitter, the parameters are transferred from the
transmitter to the receiver (see page 15).
왘
Press the jog dial.
The frequency selection appears.
왘
Press the jog dial.
Your settings are stored. The “
Tune ” menu item appears.
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Menu item Transferred receiver parameter
Balance Balance or Focus setting (“
−
15 ”/“ +15 ”)
Squelch Squelch setting (“ 5 dB ” ... “ 25 dB ”)
Mode Audio mode setting (“ Stereo ”/“ Focus ”)
High Boost Treble boost setting for output signal (“ flat ”/“ High boost ” (8 dB at 10 kHz))
Auto Lock Lock mode setting (“ Active ”/“ Inactive ”)
Limiter Limiter setting (“
−
18 dB ”, “
−
12 dB ”, “
−
6 dB ”, “ Off ”)
Exit Exits the “ Sync Settings ” submenu and returns to the extended menu
“ Advanced Menu ”
Parameter Transfer is ...
... deactivated
... activated
-60 dB
Sync
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF
-60 dB
Sync
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF