Sennheiser SK 9000, Instruction Manual

Page: 17 / 26

Using the SK 9000
16 | SK 9000
“Low cut” – Setting the low-cut filter
Via the “ Low cut ” menu item, you can set the low-cut filter. When
you are using Sennheiser microphones or the Sennheiser CI 1-4 line/
instrument cable, the bodypack transmitter automatically detects
the type of input signal present and changes the possible settings
of the “
Low cut ” menu item accordingly:
“RF mode” – Adjusting the transmission mode
The “ RF mode ” menu item allows you to adjust the transmission
mode (see the instruction manual for the Digital 9000 system).
“Display” – Selecting a standard display
The “ Display ” menu item allows you to select one out of 3 standard
displays.
“Cable” – Emulating instrument cable lengths
Via the “ Cable ” menu item, you can emulate the lengths of instru-
ment cables in 3 steps. You can use this function when you are using
the Sennheiser CI 1-4 line/instrument cable.
“Lock” – Activating/deactivating the lock mode
Via the “ Lock ” menu item, you can activate or deactivate the lock
mode. For more information on how to activate or deactivate the
lock mode, refer to page 12.
“Test tone” – Activating the 1 kHz test tone
Via the “ Test tone ” menu item, you can activate a 1 kHz test tone.
This test tone is transmitted instead of the input signal. You can use
this function for level matching your system or for the walk test.
“Reset” – Resetting the factory default settings
Via the “ Reset ” menu item, you can reset the bodypack transmitter
to its factory default settings.
Cable type Settings
Sennheiser microphone cable “ 60 Hz ”, “ 80 Hz ”, “ 100 Hz ”,
“ 120 Hz ”
Sennheiser CI 1-4 line/
instrument cable “ 30 Hz ”
Frequency Preset Name
3:59
480.000
480.000MHz 3:59
U
3:59
GUITAR