HME 46-3, HMD 46-3
02/2008
4.3
Assembly of the cable to the headset
Reference:
•
see “Exploded view HME 46-3 / HMD 46-3”, page 21.
1. Set the connector of the system cable into the cable holder (110)*.
2. Fasten the screws of the system cable with a torque of 25 Ncm
±
3 Ncm.
4.4
Assembly of the microphone arm
Reference: see “Exploded view HME 46-3 / HMD 46-3”, page 21.
1. At the inside of the microphone arm fixing is a latch
. Firstly set this latch at the right socket
position
of the cap (20).
2. Hook the microphone arm (100 or -105) into the cap (20)
.
3. Fix the microphone arm (100 or -105) with the threaded pin (10 of the cap module) to outside. Turn the
threaded pin (10 of the cap module) out to exceed in the assembled condition 0.1 to 0.3 mm over the
surface of the microphone arm fixing.
*
Only for microphone side.
PCB
PCB cable (insid
e)
20
100
10 (of the cap module)
