Getting started
14 | RS 120-W
Charging the rechargeable batteries
A complete charging cycle takes up to
18 hours
. However, before
using the headphones for the first time, charge the rechargeable bat-
teries for at least 24 hours without interruption to optimize the per-
formance of the batteries. When the rechargeable batteries are
almost empty, you will hear 3 descending sound signals from the
headphones. When the rechargeable batteries are empty, you hear a
sound, audio playback stops, and the headphones switch off.
▷
Place the headphones on the transmitter‘s headphone holder. You
may place the headphones on either side provided that the
charging contacts of the headphones and the transmitter con-
nect.
The headphones automatically switch off and the
CHARGE
LED on the transmitter lights up red. When the rechargeable bat-
teries are fully charged, the
CHARGE
LED goes off.
Adjusting the headband
For good sound quality and best possible wearing comfort, the head-
band has to be adjusted to properly fit your head. The headphones
feature an adjustable headband with a snap-in locking mechanism
for easy adjustment.
1. Wear the headphones so that the headband runs over the top of
your head. Observe the
L
and
R
markings on the outer headband
when putting the headphones on.
2. Adjust the length of the headband so that
– your ears are comfortably covered by the ear pads,
– you feel even, gentle pressure around your ears,
– a snug fit of the headband on the head is ensured.
NOTE
Damage to the headphones due to battery fluid!
If you insert non-rechargeable batteries into the battery compart-
ments, the batteries may leak during charging and can damage your
headphones.
▷
Never charge standard batteries.
When not in use, place the headphones on the headphone
holder to ensure that the rechargeable batteries are fully
charged when needed.
LED Off
