Sennheiser EVOLUTION WIRELESS G2 100, Service Manual

Page: 15 / 27

SK 100 G2, SK 300 G2, SK 500 G2
02/2005
15/27
4.5 Reading out / Changing of device data via infrared adaptor
4.5.1 Overview
You may read out and change data via the infrared adaptor. The Sennheiser service software supports the
following tasks you may want to perform:
•
Reading out the current software version and, if necessary, carrying out of a software update (file "*.s19").
•
Commissioning the receiver after a hardware replacement (e. g. replacing of a board).
•
Changing the current frequency table.
•
Changing / resetting the receivers's factory settings.
4.5.2 Required hardware
You will need the Sennheiser service package for reading in and out of device data
(“See “Special service tools” page 11.“):
For portable devices:
•
Infrared adaptor for reading out / in data (e. g. SK 100 transmitter)
For stationary devices:
•
RS232/RS485 converter with mains adaptor
•
RS232 cable for connection of PC and converter
•
RS485 cable for connection of receiver and converter
You may order the service package directly from Sennheiser:
Service package for ew G2 software, ID no. 094739, price group 161
4.5.3 Required software
You may download the service software free of charge from the Sennheiser homepage on the Internet.
In order for you to use the software, you will need the operating system Microsoft® Windows 98™ or higher
and a free COM port (RS232).
4.5.4 Information on the service software
Operating instructions for the service software are available in PDF format. These operating instructions
contain information on commissioning of the service package and reading out and in of device data.
After installation of the software, you will find the instruction manual in the Windows menu [Start].