Sennheiser EM 3731-II - ANNEXE 583, Instruction Manual

Page: 32 / 50

31
Adjustment tips for the operating menu
왘
After you have selected the frequency bank and the channel, press the
save button
8
.
The selected frequency bank and the selected channel are set. The
display changes to the selection mode of the operating menu.
Changing the receiving frequency for a channel in the
frequency bank “U”
Each receiver has seven frequency banks. Each of the channels in the
frequency banks “
1 ” to “ 6 ” has been factory-preset to a receiving
frequency (see enclosed frequency tables). The frequency bank “ U ” (user
bank) has 60 channels to store your selection of receiving frequencies. Via
the “
Tune ” menu, you can select the receiving frequencies to be stored in
the frequency bank “ U ”.
왘
Change to the setting mode of the “ Bank.Ch ” menu and select the
frequency bank “ U ” and one of the channels “ 01 ” to “ 60 ” whose
frequency you want to change and store (see “Selecting a frequency
bank and a channel” on page 30).
왘
Change to the setting mode of the “ Tune ” menu and select the
receiving frequency you want to store (see “Setting the receiving
frequency” on page 30).
The selected receiving frequency is set and stored on the selected
channel of the frequency bank “
U ”, i.e. the previously stored frequency
is overwritten. The display changes to the selection mode of the
operating menu.
Entering a name
Via the “ Name ” menu, you can enter a freely selectable name for the
receiver. The name can be displayed on the status display and can consist
of up to six characters such as:
• letters (without pronounciation marks),
• number from 0 to 9,
• special characters and spaces.
왘
Change to the setting mode of the “ Name ” menu.
The first character of the name starts flashing.
왘
Turn the jog dial
7
to select a different character.
The selected character starts flashing.
왘
Press the jog dial
7
to confirm the selected character.
The first character is accepted and stops flashing. The next character
starts flashing.
B.Ch
1 .
776.000
MHz
Freq. occupied
You can only select channels that are not occupied. If, during the
last scan, channels were detected that were occupied, these
channels are marked with a warning triangle and “
Freq. occupied ”.
Tune
776.
000
Bank
B.Ch
1.01
776.
000
MHz
B.Ch
U .01
776
UHF MHz
960
The receiving frequencies of the channels in the frequency banks
“
1 ” to “ 6 ” cannot be changed. When you have selected one of the
frequency banks “ 1 ” to “ 6 ” and then select the “ Tune ” menu, the
receiver automatically switches to channel “ 01 ” of the frequency
bank “ U ”.
B.Ch
1 .
776.000
MHz
Name
CEL
B.Ch
.Ch
.16
Squel
30
E L
+ , - | / 0 1 2 3 4 5 6
7 8 9 * ; < = >
A A B
C D E F G H I J K L M N
OPQRSTUVWXYZ
esc
s ave
syn c
digital audio
processing
syn c
DEV
M
H
z
777.005
U.01 BANK
CH
COM
AF
8 7