+
_
Pelco
Data
Out
Power
Pwr
Pwr
Connect power to the Pwr
inputs. Do not connect
power wires to the Gnd.
n.c.
The removable mounting
clip can be snapped onto a
din rail or screwed to a
panel or wall.
SCT-CRX-Pelco-Pelco
Pelco Coaxitron to Pelco RS-422 Code Translator
Size:
4.5" x 3.5" x 1.25"
Weight:
0.5 lb
Power:
9Volt to 15Volt AC or DC at 75ma
Environmental: Indoor use only
Sennetech, Inc. 6455 W. Bath Rd. Perry, MI 48872 U.S.A. Ph (517) 675 1150 Fax (517) 675 1151
The Code Translator detects Pelco coaxitron control code and converts it into Pelco RS-422 control
code for a single Pelco camera.
NOTE FOR NEW UNITS SHIPPED ON OR AFTER MARCH 01, 2016: For all new units, the baud rate
selection switches now apply to both P code
and D code. For units purchased before this date, the
baud rate selection switches apply only to P code (D code set at 2400 baud only).
Pelco
Address Switches
The range is 0~256
An invalid setting will
cause the Error in-
dicator to light up
solidly.
Tx
Indicator
Flashs when
Pelco camera
control com-
mands are
sent.
Configuration Switches
Switch1: Output Code Type
Up:
"P" Code
Down:
"D" Code
Switches 2&3: Baud Rate
2 Down 3 Down
2400
2 Up 3 Down
4800
2 Down 3 Up
9600
2 Up 3 Up
19.2k
Switch 4: "P" code parity
Up:
Even parity
Down:
No parity
Switch 5: Unassigned
Up:
Down:
Switch 6: Output Test Pattern
Up:
Test On
Down:
Test Off
Removable edge connector.
Insert a small screwdriver in
the upper slot to force open the
wire clamp. Push all the way in
to open fully. Place stripped
wire end(s) in the open clamp
and withdraw screwdriver.
Error
Indicator
Lights solidly
for any invalid
a d d r e s s
switch set-
ting.
Video
Indicator
Illuminates
when video
sync signal
is detected.
SPECIFICATIONS
Rx
Indicator
Flashs when
coaxitron con-
trol code is
detected.
High impedance looping
coaxial video connectors.
www.sennetech.net
