Seneca S6001-RTU, User Manual

Page: 50 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
50

the “VPN Box Manager”, which allows to configure the VPN
4
mode on the VPN Box and manage the
devices
5

the “VPN Client Communicator”, which lets the user connect the PC to the network (in the “Single
LAN” case) or to a specific device (in the “Point-to-Point” case)
A detailed description of “VPN Box” can be found in the “VPN Box User Manual”.
A detailed description of Z-TWS4/Z-PASS2-S/S6001-RTU VPN configuration parameters is given in 18.1.4
paragraph.
The following two sub-paragraphs give some more info about the two kinds of VPN.
10.1 “Single LAN” VPN
The above figure gives an example of a “Single LAN” VPN.
The client PC (with IP address 192.168.1.X) can connect, just as an example, to the first Z-PASS2-S by using
its 192.168.10.154 IP address and to the PLC in the Z-PASS2-S LAN by using its local IP address
192.168.10.102.
Also, two devices which lie in two different LANs of the same VPN network (e.g.: 192.168.10.101 and
192.168.20.102) can connect to each other, again using their local IP addresses.
4
Only one of the two kinds of VPN can be configured on a given VPN Box.
5
“VPN Box” functionality is available also on Seneca Z-PASS1 and Z-PASS2 products.