Seneca S6001-RTU, User Manual

Page: 25 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
25
5 LEDs signaling
5.1 Z-TWS4, Z-PASS2-S
LED Status Meaning
PWR Green ON The module is powered on
RUN Red Blinking The module is ready for use
LINK1 Yellow ON
OFF
Ethernet 1 connection detected
Ethernet 1 connection absent
ACT1 Green Blinking
OFF
There is data activity (Ethernet 1)
There is no data activity (Ethernet 1)
LINK2 Yellow ON
OFF
Ethernet 2 connection detected
Ethernet 2 connection absent
ACT2 Green Blinking
OFF
There is data activity (Ethernet 2)
There is no data activity (Ethernet 2)
RX1-2-4 Red Blinking
ON
OFF
Data reception (COM 1-2-4)
Check the connection (COM 1-2-4)
No data reception (COM 1-2-4)
TX1-2-4 Red Blinking
ON
OFF
Data transmission (COM 1-2-4)
Check the connection (COM 1-2-4)
No data transmission (COM 1-2-4)
3G PWR Green
(Z-PASS2-S only)
ON The 3G Modem is powered on
STAT Yellow
(Z-PASS2-S only)
ON
Slow Blinking
Fast Blinking
Not registered on GSM network
Registered on GSM network
Mobile Network connection active
5.2 Z-PASS2-S-R01
LED Status Meaning
PWR Green ON The module is powered on
RUN Red Blinking The module is ready for use
LAN/WAN ON The Ethernet ports are working in “LAN/WAN” mode