Seneca S6001-RTU, User Manual

Page: 114 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
114

create an empty file named SW002940_reset_cmd into the root of the USB pen;

switch off the Device;

insert the USB pen into the USB#1 port of the Device;

switch on the Device; the procedure will take some minutes to be completed; during this time,
the Device MUST NOT be switched off; during the procedure, the Device will be rebooted;

after the reboot, wait until you see the “RUN” LED blinking;

remove the USB pen;

the factory reset has been performed.
18.1.10 Modbus TCP Client Configuration
By clicking on the “Modbus TCP Client” link, in the “General Configuration” menu, you come to the
following page: