User Manual
R-GWR SERIES
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
www.seneca.it
Doc: MI00568-1-EN
Page 14
Represents the status of the sensor, if the sensor has not sent the data within the FAIL TIMEOUT time, the
STATUS field goes into fail.
ATTENTION!
IT IS POSSIBLE THAT IN SOME SITUATIONS YOU CANNOT DETECT THE CORRECT STATUS OF THE
BATTERY, AND THEREFORE IT WILL BE DISCHARGED EVEN IF THE STATUS IS OK.
4.2.2.3.
CONFIGURING A SENSOR
At each communication, the gateway sends the current configuration to each radio sensor.
ATTENTION!
IF YOU CHANGE THE CONFIGURATION OF A SENSOR IN THE R-GWR WEB SERVER, THIS WILL BE
SENT TO THE SENSOR IN THE NEXT COMMUNICATION
To configure a sensor, press the relative "SETUP" button in the "Status" section of the R-GWR web server:
SEND TIME [ x 30s] (default: 15 minutes)
Represents the time to send data to the gateway in quanta of 30 seconds
INPUT 0 (IN0)
Configures the type of operation of input0 (terminal input):
ALARM-FALLING EDGE
= Digital input active in the transition from 1-> 0 of the input signal
ALARM-EDGE
= Digital input active in the passage from 1-> 0 and from 0-> 1 of the input signal
COUNTER
= The counter on digital input IN0 is activated, the count takes place in the transition from 1-
> 0
WATER SENSOR
= The flood detection mode is activated, it also requires the Water Sensor
configuration on INPUT1.
ANALOG INPUT
= The 0-30V voltage measurement mode is activated from the IN0 input
INPUT 1 (IN1)
Configures the type of operation of input1 (digital input / magnetic reed relay):
ALARM-REED-RISING EDGE
= Digital input active in the transition from 0-> 1 of the input signal
ALARM-REED-FALLING EDGE
= Digital input active in the transition from 1-> 0 of the input signal
WATER SENSOR
= The flood detection mode is activated