6.7.4
Traffic — Filter setup
The
Traffic — Filter setup
view makes it possible to define stream filter requirements affecting the
and
views. Ten filters can be defined and enabled by the
user.
Statfilter settings:
Name:
A text string defining the filter
Enabled:
Only enabled filters are in use
Streams:
The number of streams matching filter requirements
Cast:
The type of stream:
No filtering
,
Only unicasts
or
Only multicasts
RTP:
The RTP mode:
No filtering
,
Only with RTP header
or
Only without RTP header
VLAN:
VLAN selection mode:
No filtering
,
Only tagged traffic
,
Only untagged traffic
or
Require matching specified value
(a specific VLAN ID).
IP dst:
The IP destination address mode:
No filtering
or
Require matching specified value
(a specific IP address/netmask)
IP src:
The IP source address mode:
No filtering
or
Require matching specified value
(a
specific IP address/netmask)
UDP dst:
The UDP destination mode:
No filtering
or
Require matching specified value
(a
specific UDP port number)
UDP src:
The UDP source mode:
No filtering
or
Require matching specified value
(a specific
UDP port number)
UDP payload:
The UDP payload mapping type:
No filtering
,
7 TS/UDP
or
N TS/UDP
(any integer
number of TS to UDP mapping)
Edit:
Click the Edit link to edit filter settings.
100
VB3xx 10G Probe User’s Manual version 5.3
Summary of Contents for VB330
