12
2.3.4 Connection Setup for HDMI/CVBS/SDI signal input
Connect HDMI/CVBS/SDI signal to NB100U “HDMI IN”/”AV IN”/ “YPbPr IN”/”SDI IN” port with a
HDMI /AV/YPbPr/SDI cable.
3 CHAPTER3 OPERATION GUIDE
3.1 Operating the Front Panel Interface
3.1.1 Powering Up and Initialization
Before powering-up the device, make sure that all cabling is correctly connected (refer to
chapter 2.3 of this manual). The device is correctly connected to the power inlet.
Connect the Power port and the unit is powered up and starts the initialization.
The LCD screen is lighted up, and display information as following:
There will be 3 seconds leaving for you to choose which mode you’ll start. After 3 seconds the
portable encoder will start the last mode automatically.
If you press
OK
button in the front panel, and display information as following:
Press arrow
Up
or
Down
in the front panel to choose start mode.
The initialization takes about 30 seconds to complete, and then the LCD screen display as
following
:
Note:
If the unit fails to initialize and hangs at the “booting” stage, switching off the device and
then powering up again may help. If the device still fails to initialize, please contact your service
representative for help.
Up Enter BackUp
Dn Enter Normal
Press OK Button To Choose Mode.