Sencore DMG 3000, User Manual

Page: 60 / 306

DMG 3200/3100/3000 – User Manual
Page 60 (306)
Pre-FEC_BER Bit error rate on the channel, before any FEC decoding.
5.4.2 ASI Input
The ASI input module can receive up to three/four individual ASI input streams depending on
the hardware revision. Each ASI input can support up to 213Mbit/s. To configure the module:
•
Switch to the Inputs node in the Navigation Pane
•
Select the ASI module you want to configure to display the module configuration.
Services available on all three ASI input ports will be listed in this view.
Figure 5.19 - ASI Input
The ASI node shows all configurable settings as well as the current bitrate and service
information. The following parameters are available:
Input Port on the ASI input module
Rate [Mbit/s] Incoming data rate
CC Err Continuity Counter Error – indicates that one or more packets are lost
Mode
Select one of the following modes:
o
DVB
o
DVB (SDT)
o
MPEG
o
ATSC
o
OFF
The default mode is DVB. If the incoming transport stream is not DVB
compliant, use MPEG mode instead.
Enable
Enable the corresponding input port