49
B.3.31. AT+BTLPM,n
Response
OK
Purpose
Set low power mode
Parameters
n=0: Inactivate (Default)
n=1: Activate
Description
During no data transmission, Parani-ESD can be in low power mode to save the power. It
takes a few seconds to wake the Parani-ESD out of low power mode.
B.3.32. AT&V
Response
S0:m0;S1:m1;
…
Sn:mn
OK
Purpose
Display all the S-registers
Description
All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
B.3.33. AT+PASS=$string
Response
Remote Configuration Enabled
Purpose
Input password in remote configuration mode.
Parameters
$
string
= Password (Default=
”
0000
”
)
Description
Input password for authentication in remote configuration mode.
Example
AT+PASS=1234
B.3.34. AT+CHPASS=$string
Response
OK
Purpose
Change password used in remote configuration mode.
Parameters
$
string
= New password
Description
Change password used in remote configuration mode. Password length is up to 8.
Example
AT+CHPASS=12345678
B.3.35. ATSnn?
Response
value
OK
Purpose
Display a given S-register
Parameters
nn= Address of S-register
Description
A specific S-register will be displayed.
Summary of Contents for Parani-ESD100V2
