SELVA MARINE Kingfish 25, Service Manual

Page: 140 / 398

6-14
6
3. Install the spring
9
, a new O-ring
0
, and
the pilot screw
A
, turn the pilot screw in
until it is lightly seated, and then turn it
out the specified number of turns.
È
For Europe
É
For Oceania
Installing the carburetor
Do not reuse a gasket or O-ring, always
replace it with a new one.
1. Install a new gasket
1
and the intake
manifold
2
, and then install a new gas-
ket
3
, the joint
4
, a new gasket
5
, the
carburetor
6
, a new O-ring
7
, and the
intake silencer
8
.
2. Connect the Prim Start coupler
a
.
3. Connect the throttle link rod
9
.
TIP:
To adjust the throttle link rod, see “Adjusting
the throttle link rod” (6-17) (tiller handle
model) or “Adjusting the throttle link rod” (6-
20) (remote control model).
4. Connect the blowby hose 0 and fuel
hose
A
.
5. Adjust the engine idle speed. See
“Checking the engine idle speed” (10-
10).
Pilot screw driver
B
(for Europe):
90890-06673
Pilot screw setting:
2
±
1/2 turns out (for Europe)
2 3/4
±
1/2 turns out (for Oceania)
A A
0
9
B
É È
9
8
7
6
5
3
4
2
a
1
A
0
Carburetor