SELVA MARINE ANTIBES 15XS S505XS, Owner'S Manual

Page: 19 / 47

18
OUTBOARD MOTOR FIXING
After having made all the operations of adjusting the trim-angle,
make two holes in the transom so that they correspond to the holes of the
fixation bracket. Put a layer of dope on the holes and on the screws to be
used to fix (which are with the motor). Put the motor on the transom and fix
it, paying attention that the fixing nuts must be inside the boat. Control the
tightening of nuts and levers.
Use only bolts, nuts and washers which are in the motor packing. If you
need to use other components, be sure that they are of the same quality
regarding the material and strength. Tighten the bolts and check the
tightning of bolts and levers after running the motor.
Picture No.41
REMOTE CONTROL BOX INSTALLATION
To install the remote control box and the cables we suggest
you contact an official dealer SELVA MARINE.
We suggest you contact this dealer also for the control device
installation.
An improper installation of a remote control box may cause a
sudden and unexpected loss of control, of the boat. In case or
doubts about the remote control installation, ask your SELVA
MARINE dealer.
Position of the remote control box
Normally the remote control box is supplied to be in
positioned on the right.
If you need to have it on the opposite side, ask your dealer.
When positioning the remote control box pay attention that the control
lever can be gripped and operated comfortably and without obstacles.
Even the cables must be put in order not to have any obstacle on their
patch and must not get in the way of the passengers. Be sure that the
cables are long enough and that they can't get entangled when the
steering-wheel is operating.
Picture No. 42
If the cables aren't correctly installed, they can get entangled
causing the loss of control of the boat.
https://www.boat-manuals.com/