Select.live Display Operation
Selectronic Australia
OI0009 Revision 01 Select.live User Manual
27
After Adding the device to the Portal
The following screens are displayed only after Setup Wizard and adding to the portal. The
display switches between Screen 1 and Screen 2 every 3 seconds. The backlight of the LCD
display stays off.
Screen 1: SP PRO Status 1
Screen 2: SP PRO Status 2
Parameter
Description
CLOUD
The connection status to the portal.
CLOUD: OK
–
the device is connected to the portal (has an
internet connection)
CLOUD: ERROR or NO LAN
–
the device is not connected to the
portal (has no internet connection)
IP
The IP address of the Wi-Fi or Ethernet whichever is selected in
Setup Wizard.
IP: XXX.XXX.XXX.XXX
–
the device is connected to a network
IP: Unknown
–
the device is not connected to any network
D.Ver
The firmware version of the device
Devices
The connection status of SP PRO
. If “0 of 1
Ok”, connection
with SP PRO is lost
Charge
Real-time State of charge of the battery from SP PRO in %
If the connection to Wi-Fi or Ethernet is lost, the Screen 1: SP PRO status changes to:
Note: if the SP PRO has an active event, the screen is overridden by the event
screen as shown in Section 5.4 (page 28).
--- SP PRO Status ---
Cloud:OK
IP :192.168.43.130
D.Ver:3.6.3
Devices: 1 of 1 OK
---------------------
Charge:84.9%
--- SP PRO Status ---
SN :161818
Rating:3000.0W
SoC :84.9%
Grid :0W
Load :0W
Batt :0W
Solar :0W
--- SP PRO Status ---
Cloud:OK
IP :192.168.43.130
D.Ver:3.6.3
** No Connection! **
Please check you
Wi-Fi password or
Ethernet connection
