595-526-E
2017-06-09
4. Mount the new belt
1.
Push the movable motor to its forward position,
2.
Put the belt in place, starting at the flanged belt wheel.
3.
Pull the belt over the other belt wheel(s).
4.
Gently use a screwdriver as a lever by inserting it into the hole as shown above, pushing
the motor backwards to tension the belt before tightening the motor screws. Tightening
torque 10 Nm.
5.
Check
that the belt can be moved (up-down) by finger force, 2-3 mm. Over-tightening
the belt can damage the motor bearings.
1) Mount cover on port side
1.
Before mounting the cover, ensure that all old sealant is removed from both the cover and
the motor housing.
2.
Apply new sealant Loctite 5926 in the groove on the cover. Take care to apply sealant all
the way around the groove, and on both sides of the screw holes. The screws are to be
tightened to 6 Nm.
3.
Wipe off excess sealant.
