28
1. Start by loosening the screw on the underside of the drum unit a few turns. Then loosen the two smaller
screws on each side of the line guide fitting until the line guide fitting and cover seperates. Remove the line
guide fitting. It may be necessary to loosen the screw on the underside a few extra turns for the line guide
fitting to come off.
2. Pull out the lock block.
3.
Remove the cover.
6.4 Dismantling
Never take the halyard swivel or the drum unit apart. You will find it difficult to re-assemble them correctly.
(The ball-bearings are loose and difficult to refit!). Contact your Furlex dealer if service is required.
6.4.2 Line guide and cover
6.4.1 Sail feeder
Fig. 6.4.1.c
1
2
3
Remove the screw. The nut is inte
-
grated in the plastic connector.
Bend open the connector slightly
and pull out the sail feeder - lower
end first.
Bend the connector open and
remove it.
Fig. 6.4.1.a
Fig. 6.4.1.b
Fig. 6.4.2.a
Fig. 6.4.2.b
Fig. 6.4.2.c
