Date Code 20020329
SEL-DTA2 Instruction Manual
Appendix A
Firmware Versions
and Relay Compatibility
Firmware Versions
This manual covers any SEL-DTA2 Display/Transducer Adapters that contain
firmware bearing the most recent part numbers and revision numbers listed at
the top of
To find the firmware revision number in your DTA2, type the
VERSION
command from Access Level 1 or 2. The following is an FID number with the
Part/Revision number in bold:
FID=
SEL-DTA-R209
-V22-D940406
Table A.1
Firmware Versions
Firmware
Part/Revision No.
Description of Firmware
This firmware differs from previous versions as follows:
- Setting error message correction
SEL-DTA-R211
Two stop bits: Base Product
SEL-DTA-R605
One stop bit: Base Product
This firmware differs from previous versions as follows:
- 2 1/2 element power calculation for delta fast meter
- SEL-251 demand and reset demand/peak
- Fast meter single-phase power for analog output
- One minute timeout for freeze meter function
SEL-DTA-R210
Two stop bits: Base Product
SEL-DTA-R604
One stop bit: Base Product
This firmware differs from previous versions as follows:
- FL analog output reset correction
SEL-DTA-R209
Two stop bits: Base Product
SEL-DTA-R603
One stop bit: Base Product
This firmware differs from previous versions as follows:
- Added SEL-267/167 Demand Meter Support
- Added SEL-251 Delta Version Meter Support
- Added SEL-251-1 Versions Meter Support
- Added SEL-221F/121F Fault Type 6 Support
SEL-DTA-R208
Two stop bits: Base Product
SEL-DTA-R602
One stop bit: Base Product
SEL-DTA-R207
Two stop bits: Base Product
SEL-DTA-R601
One stop bit: Base Product
