seima.com.au
limni-135-in | v 1.0 | page 1 of 2
Important — read this first!
1
Inspect the bath
before installation
, to ensure there are no visible defects. If a defect is found, do not install the bath and contact
the supplier immediately. Claims for defects will not be accepted after the product has been installed.
2
The bath must be installed by a
licensed tradesperson
. Failure to do so may void the warranty.
3
Compliance with
AS.3740 Waterproofing of Wet Areas within Residential Buildings
applies when installing baths.
4
Local authorities
may have specific installation requirements and this should be checked before installation.
5
Grade the
bath sub-floor
in accordance with requirements of local authorities. Grade sub-floor 1:60 minimum.
6
The
protective film
on the bath should be left intact during installation and should remain on the bath until first use.
Base support for the bath
1
The design of acrylic baths allows the base of the bath to be supported by
three timber support battens
.
2
Position and fix
timber support battens
to the base of the bath and the floor, using a suitable floor and wall panelling adhesive.
Ensure that the bath is neatly fitted and properly supported.
3
During installation, use a spirit level to check that the
bath rim is level
.
timber support battens
Ensure that the rim of the bath is level, using a spirit level.
Installation Guide
Limni 135 Island Bath
Protective film | Care and maintenance of the bath surface
1
There is a
protective film
on the acrylic surface of the bath at the time of purchase. This should remain intact until the bath is ready
to use to protect the bath during installation.
2
To preserve its polished finish, this bath should be cleaned with a
soft cloth using warm, soapy water or household detergent
.
Do
not
use abrasive cleaning products.
3
If accidental scratches, abrasions or burns occur, the surface finish can be restored by gentle polishing with Brasso.
4
For full warranty terms and conditions, please visit seima.com.au
Please leave this guide
with the end user.
Please note
−
All measurements are in millimetres.
−
Dimensions are nominal and subject to normal ceramic manufacturing variations of ±5mm.
−
Fixing: Use acetic cured silicone sealant. Do not use epoxy type adhesives.
−
Specifications may vary without notice as part of our continuous improvement practices.
−
Clean with a damp cloth. Do not use abrasive cleaners, liquids or pastes.
