English
0
English
1
15
10
5
0
20
15
25
29
1
22
1. Pull out the crown to the second click.
. Press the button for seconds or more using a sharp-pointed tool (e.g. ball
point pen).
. Push the crown back into the normal position.
✽
The indicator hand will point at the 0 position, and the watch resumes its normal
operation.
IMPROPER FUNCTION
When the watch stops operating even though it displays the remainder of the
power reserve, follow the instructions below to reset the built-in IC.
■
HOw TO RESET THE BUILT-IN IC
✽
If the indicator hand points at under the 0 position, sufficiently charge the watch.
Refer to “How to charge and start the watch”.
✽
By conducting this operation, the indicator hand moves to the 0 position even
though it displayed that there was remaining power reserve; however, this is not a
malfunction.
✽
If the watch does not resume normal operation even after resetting the built-in IC,
consult the retailer from whom the watch was purchased.
. Turn the crown to charge the watch at least until the indicator hand points
at the second marking above "0"(approximately hours of power reserve).
And then set the time, date, day of the week, and moon phase.
AUTOMATIC HAND ALIGNMENT
The position of the indicator hand may move out of alignment in rare cases. The
watch automatically corrects the position of the indicator hand once every
hours. While correcting the hand position, the indicator hand moves abnormally,
however, this is not a malfunction. After automatic hand alignment is performed,
the indicator hand will return to display power reserve amount.
<About the movement of the indicator hand during automatic hand alignment>
When automatic hand alignment starts, the indicator hand moves to the area under
the 0 position and vibrates, and then points at the 0 position. After automatic
hand alignment is completed, the indicator hand returns to display power reserve
amount.
