22
Printer setup details
：
3.1 Printing Mode
There are two options for uni-direction and bi-direction.
3.2 X Direction Mode
This is an option which is used for adjusting printheads alignment. It is recommended that the printheads
alignment is adjusted under 180DDPI after installing printheads. For printing pictures of other resolutions,
first choose the corresponding resolution under “X Direction Mode”, then click “Auto Adjust by 180DPI” and
“Save Parameters” under “Uni-color” and “Head Adjustment”. The software will automatically create the
corresponding adjusting parameters for printing. During actual printing, the adjusting parameters probably
need to be adjusted tinily again.
Remark: The option is only available for adjusting printhead alignment. For printing pictures, it is
unnecessary to choose the corresponding resolution due to the software can automatically get the
corresponding adjusting parameters for printing.
3.3 Media Movement after Printing
Setting the movement direction and distance(mm) of media after finish printing.
3.4 Flash Jetting Setting
There are three options,
1) (Home) Frequency(Hz): The setup for flash jetting frequency at home when it is not printing
(Flash
jetting frequency will be activated after clicking “Save Parameters” and “Home”)
.
2) (Clean) Frequency(Hz): The setup for flash jetting frequency at home during printing.
3) Num of Time(s): The setup of flash jetting time (unit: second).
3.5 Cleaning Option
There are Two options,
1) No Cleaning
2)Flash Jetting Cleaning. The “Flash Jetting Frequency” in 3.4 will be activated after choosing the
“Flash Jetting Cleaning”. The “Pass” can be set between 0-255Pass.
3.6 Color Bar Setting
Color bar setting includes 3 parts. Position of color bar, width of color bar and distance from printout; “Pos”
have 4 option, which are “no color bar”, “in the left”, “in the right” and “both side of the picture”, “Width” and
“Distance” is not available when choose no color bar; “Width” is setup for the width of the whole color bar,
software will allocated the width of 4 and 6 color’s color bar automatically; “Distance” is setup for distance
between the color bar and the printout. All width and distance unit is mm.
3.7 Feather
Feather setting, enable or disable feather while printing. Select how many points of feather is needed to
blur the pass line.
To blur the pass line
，
feather pass edge. 1) Option: Enable/Disable the feather function. 2) Nozzle: Setup
for nozzle number of feather.