19
2.7 Step Adjustment
The location for button of “Step” on the menu of shortcut is showed as the below picture:
Print the below adjusting picture by clicking the button of “Step”
Make the two lines at “0” as the standard. If the two lines at “0” are not in complete superposition, we need to adjust
by software. Enter “Setting\Option”, showed as the below picture:
Print the step adjusting picture again after inputting and saving the parameters.
While printing after completing adjustment, there will be a warp for step according to different medias. So the actual
step should be adjusted during printing!
The adjustment of software has been completed now!
Add -4
Choose “Step”
Value are
accumulated.
The media can be renamed according to
different medias, and the step offset can be
saved according to different medias.
Adjustment is
OK
！
