Seiko RP-E10 Series, Operation Manual

Page: 97 / 121

5-34
Item Description
Shifts the character displayed in [Character View] by one dot each
time you click one of these buttons, to the corresponding direction.
Any data that goes outside [Character View] is not retained.
Clear Clears all drawing in [Character View] to be blank.
*3
Undo
Reverts the state in [Character View] to its previous state.
It can be enabled for only once.
Print Prints the content of [Character View].
*3
*1: Not available when [Font Data List] of the [Registration] window contains no font
data or when a noneditable part of the international characters is selected.
*2: Areas outside the red frame in [Character View] are not reflected on [Preview].
*3: Not available when nothing is drawn in [Character View].
5.7.4 Registering Codepage
This section describes the procedures to register the codepage.
To Register New Codepage
1. Click the [Make new font data] button on the [Registration] window.
2. Enter [Size], [Type], and [Name or Country] of the new file added to [Font Data List].
3. Select the [Character View] tab and edit the character of each address.
4. Select the [Registration] tab, and then select the file whose characters you edited
from [Font Data List].
5. Click the [Register to Printer] button on the [Registration] window.
To Specify Font Data File for Registration
1. Click the [Open the font data...] button.
2. Specify a font data file to register in the [Open] dialog.
3. Click the [Open] button in the [Open] dialog.
4. Enter [Size], [Type], and [Name or Country] of the file added to [Font Data List]. (If the
font data file is binary data, the size and type are automatically determined from the
data size.)
5. Select the added file from [Font Data List] in the [Registration] window.
6. Click the [Register to Printer] button on the [Registration] window.
To Load Settings and Images from Saved Font Data File for Registration
1. Click the [Open...] button.
2. Select a saved font data file in the [Open] dialog.
3. Click the [Open] button in the [Open] dialog.
4. Select the loaded file from [Font Data List] in the [Registration] window.
5. Click the [Register to Printer] button on the [Registration] window.