
Version No. 1-3 - 09.11.2022
Doc. No. 99752500B001
10 / 27
9. Condensate management
High humidity and low temperatures inside the enclosure can lead to condensation on the evaporator.
Condensate that flows back into the enclosure can damage sensitive control electronics.
If too much condensation forms, the condensation is drained out of the cooling unit from outlets in the front
bottom cover (Position 1, 3 and 4) or directly through the bottom of the unit (Position 2). The drain pipe must
be connected wherever is most suitable for the customer application.
To install the drain pipe directly through the bottom of the unit (Position 2) please follow below steps:
Remove the top cover, middle cover, and bottom cover. The top cover does not need to be removed on
1.
the RK-7525 and RK-7555. The louver blanks that are marked with an arrow need to be removed carefully
with a flat blade screwdriver. Then a torx screwdriver is to be used to loosen the screws behind the
removed louver blanks. There is no need to completely remove the screws.
Summary of Contents for 752500B001
Page 8: ...Version No 1 3 09 11 2022 Doc No 99752500B001 8 27 7 Performance graph ...
Page 18: ...Version No 1 3 09 11 2022 Doc No 99752500B001 18 27 11 Cut Out Dimension ...
Page 19: ...Version No 1 3 09 11 2022 Doc No 99752500B001 19 27 12 Dimension H x W x D ...
Page 22: ...Version No 1 3 09 11 2022 Doc No 99752500B001 22 27 14 Wiring Diagram Power connector PE N L1 ...