RADIO CABLE
J2 RJ45 CABLE CONNECTION TO RADIO
1 PTT BRN RELAY CONTACT TO GND
2 TX AUDIO OUT BLU SEE NOTE
3 RX AUDIO IN YEL SQUELCHED AUDIO
4 TX AUDIO IN GRN MIC AUDIO
5 POWER RED 12
-
15VDC
6 GROUND BLK GROUND
7 ALERT RELAY ORG CLOSURE WITH DECODE
8 ALERT RELAY WHT CLOSURE WITH DECODE
NOTE:
TX AUDIO OUT
IS BEST CONNECTED TO A FLAT AUDIO INPUT. IF THE INPUT
HAS PRE
-
EMPHASIS (SUCH AS A MIC INPUT) THEN SELECT DE
-
EMPHASIS IN THE PRO-
GRAM MODE.
THE
RX AUDIO IN
SHOULD BE CONNECTED TO SQUELCHED AUDIO THAT DOES NOT
VERY WITH THE VOLUME CONTROL.
THE
SEI RECEIVER
CONNECTS TO
RX AUDIO IN
AUTOMATICALLY WHEN PLUGGED IN
SERIES WITH THE
ADVISOR
. (SEE PAGE 18)
GROUND
RX AUDIO IN
IF NOT USING DECODER.
TX AUDIO IN
IF NO GOOD CONNECTION FOR
TX AUDIO OUT
IS AVAILABLE THEN
YOU CAN CUT INTO THE MIC LINE AND CONNECT
TX AUDIO IN
AND
TX AUDIO OUT
IN SERIES. (SEE SCHEMATIC PAGE 31)
Summary of Contents for ADVISOR AE100
