Section 1: Sacksafoam II Overview
System Description
Sacksafoam II Model 8044 Operations Manual
(Version C)
2
System Description
The
Sacksafoam II Model SF2-8044
is used inside smaller helicopters to supply foam to the Bambi
bucket (models 8096 to 1821).
Sacksafoam II model SF2-8044 will hold up to 10 USG (38 litres) of foam concentrate. The foam is held
in two standard 5 USG (19 litre) containers within a large plastic case. The unit is self-contained and de-
signed to prevent foam from contacting the helicopter.
The Sacksafoam pump is operated by a controller box with a long wiring harness. A timer on the controller
box determines the amount of foam concentrate that is pumped into the Bambi bucket. This controller box
comes in two models; an in-dash mount and a remote mounted model.
Ground crew members should replace the foam containers as required. In areas, where a second member is
allowed on board, replacement of the container can be accomplished in flight. This same procedure applies
to foam dispensing. Either the pilot or a crew member can activate the foam dispenser.
Unpacking
Whether receiving the Sacksafoam II for the first time or unpacking it at the start of the season, ensure that
you have the following:
1.
Sacksafoam II unit
2.
Controller box with cable
3.
6 ft. (1.8 m.) breakaway hose
4.
1 male/1 female garden hose fitting
5.
Webbing tie-down straps (two), attached to the grey container.
The following operator-supplied equipment is also required:
1.
Dump hose to supply foam to the Bambi bucket (5/8" hose with a 5/8" female garden hose fitting
on one end).
Important Note
Cable and hose lengths must be determined by the operator. They will depend on the helicopter
model, Bambi bucket model and length of the cargo line/longline in use. Please refer to the Bambi
bucket operations manual.
