Segway PT i2, Reference Manual

Page: 111 / 160

99
EnglishEnglish
Attaching the Handlebar
Tool Required : Torque wrench with 3mm bit.
To attach the Handlebar to the LeanSteer Frame:
1.
Make sure the Segway PT is unplugged and powered off.
2. Align the Handlebar in place against the LeanSteer Frame using
the alignment guides. See
Figure 34 .
3. Position the Handlebar Clamp against the Handlebar.
4. Insert the 3 fasteners through the Handlebar Clamp into the
LeanSteer Frame.
5. Using the 3mm hex wrench, alternate between the 3 fasteners,
evenly tightening in small increments until the full torque setting
of 6.0 N-m (4.4 ft-lbf) is achieved.
6. Check to ensure that the gap between the Handlebar Clamp and
the LeanSteer Frame is even, and the same between the top and
bottom.
Figure 34. Secure Handlebar to LeanSteer Frame