Segway Personal Transporter i2, Parts Replacement Manual

Page: 52 / 126

6 ‐ 2 Segway® Personal Transporter i2, x2, x2 Turf Parts Replacement
When to Replace
You need to replace front or rear fascia
including without limitation if either is
physically damaged. In addition, several other
procedures require fascia or gearbox trim cover
removal and installation.
FASTENERS
•
Use only Segway-approved fasteners.
•
Do not tighten or reuse any fastener except the screws used to
attach the battery packs, wheel nuts, and LeanSteer frame.
Instead, when any other fastener is loose or removed, replace
the fastener with a new Segway-approved fastener. See
Appendix C, ”Fasteners” for more information.
•
Before using a fastener, make certain the fastener is the
correct size and type with any necessary washer and thread
lock in place (see Table C-1 on page C-1).
•
Since the pre-applied thread lock compound is intended for
single use only, reuse of fasteners is not permitted with the
exception of the wheel nuts, battery fasteners, and LeanSteer
clamp bolt.
•
Do not attempt to repair any stripped or damaged screw hole.
Instead, replace the part. If replacement part is not available,
do not reassemble.
•
Insert fasteners slowly and carefully. Do not cross-thread or
over-tighten fasteners. Tighten only to the prescribed torque.
•
Failure to adhere to these warnings could lead to serious injury
or death or damage to property.