WARNING!
Always shut down your Segway HT and unplug the Power Cord before performing any
maintenance or installing any part or accessory.
Follow these instructions carefully. Failure to follow these instructions could damage
your Segway HT and render it unsafe to use.
©2004 Segway LLC
Page 1 of 4
18250-00001ab
Segway
™
Human Transporter (HT)
Parking Stand Replacement Instructions
i Series models
Questions?
If you are missing a part, or if you need to return the product, please contact Segway
Customer Operations at 1.866.4SEGWAY (1.866.473.4929) or on our website at
www.segway.com/support/contact_us.html. Check www.segway.com for updates to this
document. Thank you.
LIMITED WARRANTY
The Segway HT Tire/Wheel Assembly Kit is a “Replacement Part” covered by the Segway
TM
Human
Transporter Limited Warranty (copy delivered with the kit.)
Kit Contents
>
(1) Parking Stand Assembly
>
(2) 4 mm Hex Drive Parking Stand Fasteners
>
(6) T-20 Drive Fender Fasteners
>
(1) 16 mm Wheel Nut
Note: Replace any fasteners you remove with the new
fasteners included in this kit.
Tools Required
>
16 mm deep socket
>
Ratchet that will accept the 16mm deep socket
>
Torque Wrench set to 50 N-m that will accept the
16 mm deep socket
>
Rubber Mallet
>
Torx T-20 wrench/bit
>
Torx T-15 wrench/bit (if your Segway HT was
purchased prior to March 2003)
>
4 mm hex wrench/bit
>
Torque Wrench set to 1.5 N-m that will accept the
Torx and Hex bits
Product Information
>
Nylon retractable stand
>
Foot activated lever
>
Spring action
